Final Project Frequency
페이지 정보
작성자 Anonymous 댓글 2건 조회 489회 작성일 20-06-24 11:24본문
Hi, I'm quite confused about the frequency restriction.
Could we set any frequency that can show the result well?
I saw the professor's comment that we can set the frequency freely.
e.g., my simulation result shows well on the 1kHz but not in 10kHz (some signal degradation obtained)
Thank you.
Could we set any frequency that can show the result well?
I saw the professor's comment that we can set the frequency freely.
e.g., my simulation result shows well on the 1kHz but not in 10kHz (some signal degradation obtained)
Thank you.
- 이전글Repost of Unanswered Question regarding Project 20.06.25
- 다음글PSPICE Final Project KP and W/L Question 20.06.24
댓글목록
final님의 댓글
final 작성일
1. you can set in 1Hz to 5MHz - using AC Sweep.
2. you should set frequency at 10kHz, and design circuit well.
This is just according to TA and professor. It might change AGAIN
Anonymous님의 댓글의 댓글
Anonymous 작성일
Please select the appropriate frequency with good gain and show the waveform. How to tune the frequency in more detail is covered in "Analog Electronic Circuits"~
I just translated the professor's comment, and I thought that we can select any frequency that shows better results, so I asked that I can use the 1kHz waveform. Thank you for your comments XD